Support · Getting Started

Set up your AirSoap in minutes

Out of the box to cleaner air in four quick steps — plus where to place it and how to read what it's telling you.

First Use

Install in four steps

Your AirSoap ships with the collection plates separate. Pop them in and you're ready.

Press in at the base of the rear panel and lift to remove the case backing.

Slide the graphene collection plates into the unit in the correct orientation, top side up.

Snap the case backing closed until it seats firmly. A loose door can cause beeping.

Connect the included power cable to an outlet and press power. Auto mode will start reading your air right away.

Best Placement

A little airflow room helps AirSoap clean a space efficiently.

Keep the unit a few feet from walls, curtains, and furniture so air can circulate freely.

Don't place it directly beside an HVAC vent — moving air can skew the air-quality sensor.

For the fastest results, run AirSoap with windows and doors closed in the room you're cleaning.

Reading the Lights

The base light scores your air in real time; Auto mode adjusts fan speed to match.

Green — Excellent. Your air is clean. AirSoap eases into a quiet, low fan speed.

Yellow — Moderate. Some particles detected. The fan steps up to clear them.

Red — Poor. Heavier pollution (smoke, dust, mold). AirSoap runs at full power until it clears.

Blinking red "Auto" (top). Time to clean the collection plates — see the Cleaning guide. Hold Auto ~10s to reset after cleaning.

Keep it running its best with a quick monthly rinse — no filters to buy.